Do you have a dog that you get groomed regularly? If you do, you’ve probably wondered how much — or even if — you’re supposed to tip your dog groomer. Treat your dog groomer as you would your own hair stylist. A 15 percent to 20 percent tip is an appropriate amount to show your appreciation for a dog grooming job well done. If your dog didn’t get clean or their nails didn’t get properly clipped, then you certainly don’t have to tip. But if you’re satisfied with the service, consider the tip part of the standard dog grooming price, and just plan it into your dog care budget so you’ll have a happy groomer and a well-groomed dog. Here are a few examples of when you should tip extra:
^ Lindblad-Toh, K.; Wade, C.M.; Mikkelsen, T.S.; Karlsson, E.K.; Jaffe, D.B.; Kamal, M.; Clamp, M.; Chang, J.L.; Kulbokas, E.J.; Zody, M.C.; Mauceli, E.; Xie, X.; Breen, M.; Wayne, R.K.; Ostrander, E.A.; Ponting, C.P.; Galibert, F.; Smith, D.R.; Dejong, P.J.; Kirkness, E.; Alvarez, P.; Biagi, T.; Brockman, W.; Butler, J.; Chin, C.W.; Cook, A.; Cuff, J.; Daly, M.J.; Decaprio, D.; et al. (2005). "Genome sequence, comparative analysis and haplotype structure of the domestic dog". Nature. 438 (7069): 803–819. Bibcode:2005Natur.438..803L. doi:10.1038/nature04338. PMID 16341006.
Clip the dog's hair methodically.[9] You can place the blade against the body safely, so long as you don't press the blade strongly into the skin. Brush against the direction of hair growth(back-brush) before running the clippers the other direction; with the direction of hair growth. Using the clippers against the growth of hair will have the same effect as back-brushing, but will leave a shorter length than the clipper blade that you are using. If you want to shave against the growth of hair, a blade size gets two blade sizes smaller when cutting against the grain. For example, when cutting with 4# against the grain check how long a 7# leaves behind when cutting with the grain. Move the clippers surely, but slowly across the dog's body to remove the hair — moving too fast might leave uneven lines. Always move the blade with the direction of the hairs' growth unless you want a shorter length than your blade claims to leave. Begin at the neck, then move down to the shoulders, under the ears, and toward the chin, throat, and chest areas. DO NOT use a size seven or any skip blades around the throat area or any flaps on the body that can fit between the teeth, such as the Achilles' tendons, arm pits, genital area, tip of tail, or anus. Then, clip the dog's back and sides. Finally, clip the hair on the dog's legs. Be careful when cutting the neck with any blade as it's the most dangerous to cut. Never cut straight down, do so at angles to avoid flaps you can't see in the neck getting cut.

Soak your dog thoroughly. Make sure your dog's coat is completely wet before you start applying shampoo to it. If your dog isn't afraid, you can buy and use a hose and water pressurizer attachment for the faucet. This is especially helpful if you have a large dog or one with a double-coat. AVOID getting water in your dog's ears. Water in the ears can cause an infection. Please be sure to only spray water/rinse water up to the dog's neck. The head can be cleaned separately (see below for instructions).
Rinse your dog thoroughly. As long as you see dirt or soap bubbles in the water coming off of an area, keep rinsing. You can use the same method you used to soak the dog's coat before shampooing. If your dog is too afraid of running water or the bath in general and can't be done on your own, there are veterinarians who can give proper sedation, not too much, to allow you to groom in a couple of hours or can groom the dog themselves. Touch the dog all over to feel for any shampoo especially the chest area and in between the legs they are hard to get. To test it, rub the fur in between you fingers and pull softly, if it feels squeaky then it's clean.
Experienced pet stylists hired from outside the company must complete a personal skill evaluation by a Petco Certified Pet Stylist or Grooming Salon Leader, as well as four weeks of safety and pet grooming operations training. They must also complete and pass a technical skills assessment within 14 days of hire. If the candidate does not pass the technical evaluations, they must complete Petco's 12-week Pet Stylist Apprentice & Certification program and retake the skills assessment.
×